21.12. Specifying CPU Architecture

as may be told to assemble for a particular CPU architecture with the .arch cpu_type directive. This directive enables a warning when gas detects an instruction that is not supported on the CPU specified. The choices for cpu_type are:

i8086 i186 i286 i386
i486 i586 i686 pentium
pentiumpro pentium4 k6 athlon
sledgehammer    

Apart from the warning, there are only two other effects on as operation; Firstly, if you specify a CPU other than i486, then shift by one instructions such as sarl $1, %eax will automatically use a two byte opcode sequence. The larger three byte opcode sequence is used on the 486 (and when no architecture is specified) because it executes faster on the 486. Note that you can explicitly request the two byte opcode by writing sarl %eax. Secondly, if you specify i8086, i186, or i286, and .code16 or .code16gcc then byte offset conditional jumps will be promoted when necessary to a two instruction sequence consisting of a conditional jump of the opposite sense around an unconditional jump to the target.

Following the CPU architecture, you may specify jumps or nojumps to control automatic promotion of conditional jumps. jumps is the default, and enables jump promotion; All external jumps will be of the long variety, and file-local jumps will be promoted as necessary. (Section 21.7 Handling of Jump Instructions) nojumps leaves external conditional jumps as byte offset jumps, and warns about file-local conditional jumps that as promotes. Unconditional jumps are treated as for jumps.

For example

 .arch i8086,nojumps